This rear wrap grip is available in both granulate and rubber textures. This grip has full coverage on the side panels below the thumb rest, ample coverage on the backstrap, and three finger wraps for the finger groves under the trigger guard. This grip was designed for Gen5. This grip sticks extremely well even with the Rough Textured Frame (RTF). Gen5 models will need to be centered on the backstrap to account for different backstrap sizes and may require minimal trimming around the new larger magazine release button.
- 100% made in the USA
- Custom designed and manufactured for this specific firearm for an OEM quality fit and finish
- Low profile grip adds minimal bulk/size
- Available in granulate texture - Often referred to as sandpaper or skateboard tape, this provides positive grip on the firearm and best suited for holster carry and competition shooting.
- Available in rubber texture - This textured rubber grip provides positive grip on the firearm and is more commonly used for concealed carry (less likely to irritate skin or snag on clothing) and users with softer hands.
- Easy to install within minutes (proper installation requires a hair dryer or heat gun)
- Instructions and cleaning pad included
- Most cleaning solutions do not harm the grip, but avoid aerosol based solvents like CLP.
- Adhesive will not move once properly installed and can be easily removed with little to no residue.
*Weapon Sold Seperately
| Product Specs | |
| Color | Black |
Talon Grips
TALON Grips was founded in 2009 out of necessity by a law enforcement officer, competitive shooter and armor. In both hot conditions and cold conditions, polymer grips become slick. Factory stippling can increase friction slightly, but it is still slippery plastic.TALON Grips has a U.S. Patented design that utilizes a single grip to wrap around the handle and provide maximum coverage with minimal bulk. Both TALON Grips materials are thin (less than .5 millimeters) and add virtually zero bulk to the firearm while providing a rock solid grip. Because the grips are designed to stick to polymer, they last longer, and they will come off clean when it is time to replace or remove the grip.
